LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2023 >> E-Transit Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 412 (Four-Wheel Drive Systems) >> Diagnosis And Testing >> Four-Wheel Drive Systems >> Pinpoint Tests >> Pinpoint Test H: Module Configuration Faults
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test H: Module Configuration Faults

WARNING: This page is about a different car, the 2023 Ford Transit-350 HD, 2023 Ford Transit-350, 2023 Ford Transit-250, and 2023 Ford Transit-150. However, it is still accessible from the selected car via links, so may be relevant.
  1. Normal Operation and Fault Conditions 

    A new AWD receives and saves vehicle identification (VID) block information from the PCM and BCM when the new AWD module powers up for the first time. During each subsequent module wake up, the AWD module compares the stored values to those being broadcast by the PCM and BCM. The diagnostic tool can be used to initiate a relearn procedure for the AWD module.

    DTC Fault Trigger Conditions 

    DTC Description Fault Trigger Condition
    AWD P0630:00 VIN Not Programmed or Incompatible - ECM/PCM: No Sub Type Information The VIN stored in the AWD module does not match the value being passed by the PCM.
    AWD P160A:00 Control Module Vehicle Options Reconfiguration Error: No Sub Type Information The VIN, tire circumference, and axle ratio that are stored in the AWD module do not match the values being passed by the BCM.
    AWD U2100:00 Initial Configuration Not Complete: No Sub Type Information Sets when the AWD module detects initial configuration not complete.
    AWD U2101:00 Control Module Configuration Incompatible: No Sub Type Information Sets when the AWD module detects control module configuration incompatible.
    AWD U2200:00 Control Module Configuration Memory Corrupt: No Sub Type Information This DTC sets due to an internal fault with the AWD module.

    Possible Sources 

    • Incomplete PMI procedure on suspect module
    • Loose AWD module ground.
    • Improper module replacement
    • AWD module

  2. H1 CARRY OUT THE AWD (ALL-WHEEL DRIVE) - RELEARN VEHICLE DATA FUNCTION

    • Enter the following diagnostic mode: AWD - Relearn vehicle data.

    • Enter the following diagnostic mode: Clear and Retest AWD CM DTC self-test.

    Did the DTC reset? 

    Yes  GO to  H2
    No  The repair is complete.

  3. H2 CHECK THE AWD (ALL-WHEEL DRIVE) MODULE GROUND

    • Ignition OFF.

    • Disconnect AWD module C281.

    • Inspect harness connector for damage. Verify terminals are not splayed, damaged, or pushed out of the connector.

    • Measure:
      Positive Lead Measurement / Action Negative Lead
      C281 Pin 46
      GFD786457Courtesy of FORD MOTOR COMPANY
      		 Ground

    Was the resistance less than 3 ohms? 

    Yes  GO to  H3
    No  REPAIR the open circuit

  4. H3 CARRY OUT PMI (PROGRAMMABLE MODULE INSTALLATION) ON SUSPECT MODULE USING AS-BUILT DATA

    • Using a diagnostic scan tool, carry out the PMI procedure on the suspect module using As-Built data.

    • Enter the following diagnostic mode: AWD - Relearn vehicle data.

    • Enter the following diagnostic mode: Clear and Retest AWD CM DTC self-test.

    Did the DTC set? 

    Yes  INSTALL a new AWD module. REFER to: All-Wheel Drive (AWD) Module .
    No  The repair is complete.
scientia non olet · About LEMON Manuals