Wiper System And Washer System DTCS
Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: .
| DTC | Description | Action |
|---|---|---|
| B130F:12 | Run Accessory Control: Circuit Short To Battery | GO to Pinpoint Test A |
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | GO to Pinpoint Test A |
| B130F:14 | Run Accessory Control: Circuit Short To Ground or Open | GO to Pinpoint Test D |
| B1008:09 | Wiper Mode Switch: Component Failure | GO to Pinpoint Test A |
| B1008:09 | Wiper Mode Switch: Component Failure | GO to Pinpoint Test D |
| B1051:09 | Front Washer Switch: Component Failure | GO to Pinpoint Test H |
| B10AD:02 | Rain Sensor: General Signal Failure | GO to Pinpoint Test F |
| B10AD:08 | Rain Sensor: Bus Signal / Message Failure | GO to Pinpoint Test F |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | GO to Pinpoint Test J |
| B10AD:55 | : Rain Sensor:Not Configured | GO to Pinpoint Test K |
| B1131:02 | Wiper motor module: General Signal Failure | GO to Pinpoint Test A |
| B1131:02 | Wiper Motor Module: General Signal Failure | GO to Pinpoint Test D |
| B1131:08 | Wiper motor module: Bus Signal / Message Failure | GO to Pinpoint Test B |
| B1131:11 | Wiper motor module: Circuit Short to Ground | GO to Pinpoint Test B |
| B1131:49 | Wiper Motor Module: Internal Electronic Failure | GO to Pinpoint Test L |
| B1131:55 | : Wiper Motor Module: Not Configured | GO to Pinpoint Test K |
| B12F7:09 | Single Wipe Switch: Component Failure | GO to Pinpoint Test A |