Tire Pressure Monitoring System (TPMS) Sensor Location Calibration: Notes

WARNING: This page is about a different car, the 2020 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING .

Special Tool(s) / General Equipment

Courtesy of FORD MOTOR COMPANY	204-D081A (204-D081) Tire Pressure Monitor (TPMS)
Ford Diagnostic Equipment

Programming

NOTE: The TPMS can be placed into learn mode using a diagnostic scan tool or manually where a diagnostic scan tool is not available.

NOTE: The horn will sound once and the TPMS indicator will flash if the training mode has been entered successfully. If equipped, the message center will display TRAIN Left Front (LF) TIRE.

NOTE: Enter Training Mode With IDS Scan Tool
1. Select Chassis.
2. Select TPMS.
3. Select Training Mode. Use the General Equipment: Ford Diagnostic Equipment
NOTE: Enter Training Mode With FDRS Scan Tool
1. Select Toolbox.
2. Select BCM.
3. Select BCM -- TPMS Initialization. Use the General Equipment: Ford Diagnostic Equipment

Programming

NOTE: Enter Training Mode Without Scan Tool

NOTE: The horn will sound once and the TPMS indicator will flash if the training mode has been entered successfully. If equipped, the message center will display TRAIN Left Front (LF) TIRE.

With the ignition OFF, press and release the brake pedal.
Using the start/stop switch, position the ignition from OFF to RUN 3 times, ending in the RUN position.
Press and release the brake pedal.
Position the ignition to OFF position.
Using the start/stop switch, position the ignition from OFF to RUN 3 times, ending in the RUN position.