LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2023 >> Edge ST-Line >> Repair and Diagnosis >> External Pages >> Different car >> Section 577 (Tire Pressure Monitoring System (TPMS)) >> Diagnosis And Testing >> Tire Pressure Monitoring System (TPMS) >> Diagnostic Trouble Code (DTC) Chart
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Trouble Code (DTC) Chart

WARNING: This page is about a different car, the 2021 Ford F-150. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods .

Module DTC Description Action
BCM B1182:00 Tire Pressure Monitoring System: No Sub Type Information GO to Pinpoint Test A 
BCM B1182:55 Tire Pressure Monitoring System: Not Configured GO to Pinpoint Test L 
BCM B124D:02 Tire Pressure Sensor: General Signal Failure GO to Pinpoint Test B 
BCM B1251:00 Tire Pressure Sensor Low Battery: No Sub Type Information GO to Pinpoint Test C 
BCM B1254:51 Right Rear (Outside on Duel Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed GO to Pinpoint Test L 
BCM B1255:51 Left Rear (Outside On Duel Wheel) Tire Pressure Sensor and Transmitter Assembly: Not Programmed GO to Pinpoint Test L 
BCM C1A56:51 Left Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed GO to Pinpoint Test L 
BCM C1A58:51 Right Front Tire Pressure Sensor and Transmitter Assembly: Not Programmed GO to Pinpoint Test L 
BCM U0559:56 Invalid Data Received From Radio Transceiver: Invalid/Incompatible Configuration GO to Pinpoint Test K 
RTM U0146:00 Lost Communication With Gateway "A": No Sub Type Information GO to Pinpoint Test H 
RTM U0401:00 Invalid Data Received from ECM / PCM "A": No Sub Type Information GO to Pinpoint Test J 
RTM U0401:82 Invalid Data Received from ECM / PCM "A": Alive / Sequence Counter Incorrect / Not Updated GO to Pinpoint Test J 
RTM U1A00:00 Private Communication Network: No Sub Type Information GO to Pinpoint Test I 
RTM U2100:00 Initial Configuration Not Complete: No Sub Type Information GO to Pinpoint Test K 
RTM U3000:04 Control Module: System Internal Failures GO to Pinpoint Test K