Power Roof Opening Panel Initialization

WARNING: This page is about a different car, the 2022 Lincoln Nautilus. However, it is still accessible from the selected car via links, so may be relevant.

For information on Ford Color Coded Illustrations refer to OEM COLOR CODING

Initialization

WARNING: Keep objects and body parts clear of the glass panel when carrying out the initialization procedure. During the initialization procedure, the glass panel closes with high force and cannot detect objects in its path. Failure to follow this instruction may result in serious personal injury.

NOTE: The roof opening panel motor must be initialized when repairs are carried out on the roof opening panel system, including: any time the roof opening panel motor has been removed, the roof opening panel glass (fixed panoramic or sliding) has been removed or adjusted, or if the roof opening panel frame has been removed.

- For sliding glass initialization, place the shield in the OPEN position and sliding glass in the CLOSED position.
- For shield initialization, place the sliding glass and the shield in the CLOSED position.
- For sliding glass initialization,
  Open driver's door and cycle ignition ON, OFF, ON.
- For shield initialization,
  Open driver's door and cycle ignition ON, OFF, ON.
NOTE: Steps 3 to 5 must be performed within 3 seconds.

NOTE: Steps 3 to 5 are to set up the overhead console to accept roof opening panel switch inputs to be held for up to a maximum of 150 seconds. Normally, the overhead console will consider the switch stuck after 30 seconds and ignore those longer inputs from the switch.
Press the left map light switch once turning the lamp on.
Without pausing, press and release the right map light switch four times ending with the lamp off.
Without pausing, press and release the left map light switch once turning the lamp off.
NOTE: Make sure to hold the switch for the entire process.
- For sliding glass initialization, press and hold the glass close switch within 3-5 seconds, movement of the glass panel will begin within 10 seconds. Continue to hold the glass close switch until the glass panel moves full OPEN and full CLOSED. Once CLOSED release the glass close switch and test for normal operation.
- For shield initialization, press and hold the shield close switch. While holding the switch, the shield will first stall forward, then move to the open position, and back to the close position. Once this has occurred, the initialization has been completed and the switch can be released.