LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2023 >> Edge ST >> Repair and Diagnosis >> External Pages >> Different car >> Section 1045 (Anti-Lock Brake System (Abs) And Stability Control) >> Diagnosis And Testing >> Anti-Lock Brake System (ABS) and Stability Control >> Pinpoint Tests >> Pinpoint Test Z: Module Configuration Concern
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pinpoint Test Z: Module Configuration Concern

WARNING: This page is about a different car, the 2023 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.

Normal Operation and Fault Conditions 

During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC is set.

DTC Fault Trigger Conditions 

DTC Description Fault Trigger Condition
ABS C05CC:00 Brake Master Cylinder Piston Position Sensor 'A' Circuit Range/Performance: No Sub Type Information Sets due to incomplete or improper module programming procedures.
ABS C05CF:00 Brake Master Cylinder Piston Position Sensor 'B' Circuit Range/Performance: No Sub Type Information Sets due to incomplete or improper module programming procedures.
ABS C102E:48 Stability Control System: Supervision Software Failure Sets due to incomplete or improper module programming procedures.
ABS P0604:8F Internal Control Module Random Access Memory (RAM) Error: Erratic Sets due to incomplete or improper module programming procedures.
ABS U2017:57 Control Module Software #2: Invalid/Incompatible Software Component Sets if the RSC calibration variant and the ABS module configuration do not match.
ABS U2017:93 Control Module Software #2: No Operation Sets if the RSC control logic cannot initialize after stable driving conditions are detected. This is usually due to an incomplete or improper module programming procedures.
ABS U2018:57 Control Module Software #3: Invalid/Incompatible Software Component Sets if the selectable drive mode software and the ABS module configuration do not match.
ABS U202B:61 In-Use Application Signing Key: Signal Calculation Failure Sets due to incomplete or improper module programming procedures. Detects a non-production bootloader file is present or an ABS module with production boot is unlocked
ABS U202B:62 In-Use Application Signing Key: Signal Compare Failure Sets due to incomplete or improper module programming procedures. Detects non-production software in the ABS module.
ABS U2100:00 Initial Configuration Not Complete: No Sub Type Information Sets due to incomplete or improper module programming procedures.
ABS U2101:00 Control Module Configuration Incompatible: No Sub Type Information Sets due to incomplete or improper module programming procedures.
ABS U2200:00 Control Module Configuration Memory Corrupt: No Sub Type Information Sets due to incomplete or improper module programming procedures.

Possible Sources 

scientia non olet · About LEMON Manuals