Pinpoint Test Z: Module Configuration Concern
WARNING: This page is about a different car, the 2022 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Normal Operation and Fault Conditions
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC is set.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS C1018:61 | Regenerative Braking: Signal Calculation Failure | Sets due to incomplete or improper module programming procedures. |
| ABS C101F:46 | Generic Valve Failure: Calibration/Parameter Memory Failure | Sets due to incomplete or improper module programming procedures. |
| ABS C101F:49 | Generic Valve Failure: Internal Electronic Failure | Sets due to incomplete or improper module programming procedures. |
| ABS U0300:51 | Internal Control Module Software Incompatibility: Not Programmed | Sets due to incomplete or improper module programming procedures. |
| ABS U2017:57 | Control Module Software #2: Invalid/Incompatible Software Component | Sets if the RSC calibration variant and the ABS module configuration do not match. |
| ABS U2017:93 | Control Module Software #2: No Operation | Sets if the RSC control logic cannot initialize after stable driving conditions are detected. This is usually due to an incomplete or improper module programming procedures. |
| ABS U2018:57 | Control Module Software #3: Invalid/Incompatible Software Component | Sets if the selectable drive mode software and the ABS module configuration do not match. |
| ABS U2024:51 | Control Module Cal-Config Data: Not Programmed | Sets due to incomplete or improper module programming procedures. |
| ABS U2100:00 | Initial Configuration Not Complete: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
| ABS U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | Sets due to incomplete or improper module programming procedures. |
Possible Sources
- Incomplete programming procedure
- Improper programming procedure
- EBB unit (vehicles with electric boost)
- ABS module (vehicles with vacuum boost)