Pinpoint Test BQ: PSCM (Power Steering Control Module) DTC (Diagnostic Trouble Code) U2100 Initial Configuration Not Complete
WARNING: This page is about a different car, the 2022 Ford Police Interceptor Utility and 2022 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
Normal Operation and Fault Conditions
Description
- Description
- When a new EPAS gear is installed, the PSCM is blank and must be configured with the vehicle information. Configuration is checked during initial PSCM power up (ignition ON) with the voltage supply to the PSCM greater than 6 volts.
- REFER to: Power Steering - System Operation and Component Description
Pinpoint Test Applicability
- Pinpoint Test Applicability
- This test applies to PSCM DTC U2100 Initial Configuration not complete only. It does not apply to any other module except the PSCM.
DTC Diagnostic Strategy
- DTC Diagnostic Strategy
- If the module DTC list results in a large number of Diagnostic Trouble Codes (DTCs), diagnose all module hard faults first (C102D, C1B00, C200B, C200C, C200D, U2011 and U3000) before diagnosing any network faults (lost communication or invalid data). If voltage concern Diagnostic Trouble Codes (DTCs) are present, diagnose those after any module hard faults and before any network faults. Diagnose all current and active Diagnostic Trouble Codes (DTCs) before diagnosing any historic Diagnostic Trouble Codes (DTCs).
Pinpoint Test Purpose
- Pinpoint Test Purpose
- To verify PSCM DTC U2100:xx is present and provide diagnostics if DTC U2100:xx is currently active in the PSCM.
Diagnostic Aids
- Diagnostic Aids
- REFER to: Module Configuration - System Operation and Component Description
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| PSCM U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC is set if the initial PSCM configuration was not carried out or if the configuration fails. |
Possible Sources
- PSCM not configured
- PSCM configuration not complete
Visual Inspection and Pre-checks
- This DTC is set if the complete PSCM configuration was not carried out or if the configuration fails.
Pinpoint Tests BQ: PSCM DTC U2100 Initial Configuration Not Complete