DTC Chart: Body Control Module (BCM)

WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .

DTC	Description	Action
B1277:11	Reverse Lamp: Circuit Short To Ground	GO to Pinpoint Test A
B1277:15	Reverse Lamp: Circuit Short To Battery or Open	If the reversing lamps are is inoperative, GO to Pinpoint Test A If the reversing lamps are always on, GO to Pinpoint Test C
U1000:00	Solid State Driver Protection Active -Driver Disabled: No Sub Type Information	The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCM cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Body Control Module (BCM) - System Operation and Component Description .
U3000:49	Control Module: Internal Electronic Failure	The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCM can withstand. The cause of the excessive current draw MUST be corrected before a new BCM is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, Refer to BCM Hardware Testing . For additional information on BCM Field Effect Transistor (FET) protection, REFER to: Body Control Module (BCM) - System Operation and Component Description .
For other BCM Diagnostic Trouble Codes (DTCs)	-	REFER to: Body Control Module (BCM) .