DTC Chart: BCMB (Auxiliary Lighting Control Module [ALCM])

WARNING: This page is about a different car, the 2018 Ford F-550 Super Duty, 2018 Ford F-450 Super Duty, 2018 Ford F-350 Super Duty, and 2018 Ford F-250 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.

Diagnostics in this article assume a certain skill level and knowledge of Ford-specific diagnostic practices. Refer to: Diagnostic Methods .

NOTE: The Auxiliary Lighting Control Module (ALCM) is referred to as the BCMB by the diagnostic scan tool.

DTC	Description	Action
B132B:11	Left Stop/Turn Lamp: Circuit Short To Ground	GO to Pinpoint Test E
B132B:15	Left Stop/Turn Lamp: Circuit Short To Battery or Open	If the lamp is inoperative, GO to Pinpoint Test E If the lamp is always on, GO to Pinpoint Test G
B132C:11	Right Stop/Turn Lamp: Circuit Short To Ground	GO to Pinpoint Test E
B132C:15	Right Stop/Turn Lamp: Circuit Short To Battery or Open	If the lamp is inoperative, GO to Pinpoint Test E If the lamp is always on, GO to Pinpoint Test G
U1000:00	Solid State Driver Protection Active -Driver Disabled: No Sub Type Information	The module has temporarily disabled an output because an excessive current draw exists (such as a short to ground). The BCMB cannot enable the output until the cause of the short is corrected. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test.
U3000:49	Control Module: Internal Electronic Failure	The module has permanently disabled an output because an excessive current draw fault (such as a short to ground) has exceeded the limits that the BCMB can withstand. The cause of the excessive current draw MUST be corrected before a new BCMB is installed. ADDRESS all other Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, INSTALL a new BCMB.
For other BCMB Diagnostic Trouble Codes (DTCs)	-	REFER to: Headlamps .