Pinpoint Test An: Stability Control Sensor Initialization Fault
WARNING: This page is about a different car, the 2023 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
Normal Operation and Fault Conditions
The ABS module monitors various inputs and compares the values to what should be expected. If the values received are out of range or not what is expected, the ABS module sets a DTC. When a new ABS module or RCM is installed, the stability control sensors in the RCM must be initialized. This is accomplished using a diagnostic scan tool to run the ABS Calibration routine.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS C0062:54 | Longitudinal Acceleration Sensor: Missing Calibration | Sets when the ABS module detects the stability sensors in the RCM have not been calibrated or the calibration has been lost. |
Possible Sources
- ABS Calibration routine not carried out
- RCM concern
- EBB unit