Pinpoint Test R: Abs Module Communication Concern With CCM
WARNING: This page is about a different car, the 2023 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
Normal Operation and Fault Conditions
The CCM communicates with the IPMA over a private CAN. The IPMA sends the CCM messages to the GWM over the HS-CAN2. The GWM relays these messages to the ABS module over the FD-CAN. If the ABS module does not receive these messages within the allotted time frame or if the messages contain invalid data, the module sets a DTC. This can be due to a CCM failure, a circuit failure on the network or an excessive load on the network. For information on the messages sent to the ABS module by the CCM and IPMA, refer to Network Message Chart , Description and Operation in the Service Articles.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Condition |
|---|---|---|
| ABS U2107:00 | Collision Mitigation By Braking: No Sub Type Information | This DTC sets when the collision deceleration message from the is sent too often or the duration of the message is too long. |
Possible Sources
- Network communication concern
- CCM