Powertrain Control Module (PCM): Installation
- To install, reverse the removal procedure.
-
NOTE: This step is only necessary when installing a new component.
Upload the module information from the diagnostic tool using the Programmable Modules Installation routine. Refer to: Module Configuration - System Operation and Component Description
(418-01A Module Configuration, Description and Operation). Use the General Equipment: Ford Diagnostic Equipment
-
NOTE: This step is only necessary when installing a new component.
Using FDRS, carry out the Trusted Real-Time Operation Network (TRON) Module Authentication procedure. SELECT TRON Diagnosis and Repair and follow the on screen instructions. Refer to: Module Programming .
-
NOTE: This step is only necessary when installing a new component.
Reprogram the Passive Anti-Theft System (PATS). Refer to: Anti-Theft Key Programming - Scan Tool .
-
NOTE: This step is only necessary when installing a new component.
Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
-
NOTE: This step is only necessary when installing a new component.
Transmission strategy download procedure should be performed when a new PCM has been installed in the vehicle. Refer to: Transmission Strategy Download .