LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2024 >> F-150 Lightning Pro >> Repair and Diagnosis >> External Pages >> Different car >> Section 739 (SECM Guided Routine Testing) >> DTC/Symptom Selection >> DTC Index >> SECM - Steering Effort Control Module >> DTC C1B00: Steering Angle Sensor
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC C1B00: Steering Angle Sensor

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2022 Lincoln Navigator, 2022 Lincoln Nautilus, 2022 Lincoln Corsair, 2022 Lincoln Aviator, and 2022 Ford Transit-350 HD. However, it is still accessible from the selected car via links, so may be relevant.
Failure Action
81 This DTC sets when the SECM receives invalid data from the steering wheel angle quality factor or steering wheel angle integrity quality factor messages. SET the ignition to ON and, using a diagnostic scan tool, CARRY OUT the SASM Module Reset routine. Using a diagnostic scan tool, CLEAR the SECM DTCs. SET the ignition to OFF and then START the engine and WAIT at least 20 seconds for the SECM to wake up and test the adaptive steering system. Using a diagnostic scan tool, CARRY OUT the SECM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the Supplemental Restraint System article.
82 This DTC sets when the SECM receives invalid data from the steering wheel angle message counter check or steering wheel angle integrity counter check messages. SET the ignition to ON and, using a diagnostic scan tool, CARRY OUT the SASM Module Reset routine. Using a diagnostic scan tool, CLEAR the SECM DTCs. SET the ignition to OFF and then START the engine and WAIT at least 20 seconds for the SECM to wake up and test the adaptive steering system. Using a diagnostic scan tool, CARRY OUT the SECM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the Supplemental Restraint System article.
83 This DTC sets when the SECM receives invalid data from the steering wheel angle checksum check or steering wheel angle integrity check messages. SET the ignition to ON and, using a diagnostic scan tool, CARRY OUT the SASM Module Reset routine. Using a diagnostic scan tool, CLEAR the SECM DTCs. SET the ignition to OFF and then START the engine and WAIT at least 20 seconds for the SECM to wake up and test the adaptive steering system. Using a diagnostic scan tool, CARRY OUT the SECM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the Supplemental Restraint System article.
87 This DTC sets when the SECM does not receive steering wheel angle messages from the SASM within a predetermined time frame. SET the ignition to ON and, using a diagnostic scan tool, CARRY OUT the SASM Module Reset routine. Using a diagnostic scan tool, CLEAR the SECM DTCs. SET the ignition to OFF and then START the engine and WAIT at least 20 seconds for the SECM to wake up and test the adaptive steering system. Using a diagnostic scan tool, CARRY OUT the SECM self-test. If the DTC returns, INSTALL a new SASM-clockspring assembly. REFER to the Supplemental Restraint System article.
scientia non olet · About LEMON Manuals