Push Button Start System

This vehicle is equipped with a PATS that disables the engine from cranking if an un-programmed PATS key is used or an invalid PCM ID is received. The PATS is controlled by the BCM. If there is a PATS concern that disables the engine, the to be disabled, the IPC displays the corresponding message in the message center. For additional information, Refer to: Passive Anti-Theft System (PATS) - Component Location .

Ignition modes are controlled by the RFA module and the BCM. For additional information on the ignition switch - push button start modes, Refer to: Steering Wheel and Column Electrical Components - System Operation and Component Description .

The ignition switch - push button start is connected to the RFA module and the BCM as a backup in case of a failure. If there is a circuit failure to either module from the ignition switch - push button start, the modules communicate the ignition switch - push button start request to each other over the MS-CAN.

During a start event the ignition switch - push button start is pressed in combination with either the brake pedal (automatic transmission) or the clutch pedal (manual transmission) input. The RFA module, the BCM and the PCM receive a request to start the engine. The PCM recognizes the correct inputs and provides voltage and ground to energize the starter relay coil and close the starter relay contacts. The starter relay contacts close, providing voltage to the starter solenoid, allowing the starter motor to crank the engine. The PCM disengages the starter motor once an engine RPM threshold is reached, a set crank time is exceeded or the ignition switch - push button start is pressed, indicating an engine shutdown.