Programming the Transmitter

1. Ground pin 4 to pin 8 of the Data Link Connector (DLC).
^ The receiver will respond by locking and unlocking the doors and activating the liftgate window release (E54 only) within 2 seconds.
2. Press and hold the "LOCK" and "UNLOCK" buttons simultaneously, on the first transmitter to be programmed, until the locks cycle (approximately 10 seconds).
3. Repeat step 2 for the second transmitter to be programmed (if available).
^ The receiver will respond by locking and unlocking the doors and activating the liftgate window release (E54 only) within 2 seconds.
4. Remove the jumper wire from the DLC.
5. Transmitter operation is verified by locking and unlocking the doors and activating the liftgate window (E54 only).