Test J: Memory Seat Feature Inoperative
- If diagnostic system check was performed, go to next step. If diagnostic system check was not performed, see DIAGNOSTIC SYSTEM CHECK under SELF-DIAGNOSTIC SYSTEM.
- Operate memory seat system. If memory seat system operates correctly, check for intermittent problem. If memory seat does not operate correctly, go to next step.
- Disconnect memory seat module. Connect a test lamp between battery positive voltage and each memory seat switch signal circuits (one at a time) and operate each switch respectively. See WIRING DIAGRAMS . If test lamp illuminates for each signal circuit when switch is depressed, go to step 5 . If test lamp does not illuminate at proper time, go to next step.
- Test for an open in memory seat switch signal circuit. If problem is found, repair as necessary and then go to step 9 . If problem is not found, go to step 6 .
- Inspect for poor connections at harness connector of memory seat module. If problem is found, repair as necessary and then go to step 9 . If problem is not found, go to step 7 .
- Inspect for poor connections at harness connector of seat adjuster switch. If problem is found, repair as necessary and then go to step 9 . If problem is not found, go to step 8 .
- Replace memory seat module. After completing repairs, go to step 9 .
- Replace seat adjuster switch. After completing repairs, go next step.
- Operate memory seat system in order to verify repair.