Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Ensure the lock washers are fully seated, completely exposing the bolt threads.

Install the video assembly to the vehicle.
Lift the and adjust the video assembly in order to install the T-hook (1) to the video player bracket. Ensure the T-hook is fully seated to the bracket.
Support the front of the video assembly and connect the video assembly electrical connector (2).
Align the retaining fastener (3) to the corresponding hole in the video player bracket.

Fig 1: Removing/Installing Video Assembly & Retaining Fastener
Courtesy of GENERAL MOTORS CORP.
Raise the front of the video assembly to install the retaining fastener (3).
Partially install the rear retaining bolts.
Adjust the video display screen to a full open position.
Partially install the front retaining bolts.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Fully seat the retaining bolts.
Tighten: Tighten the bolts to 9 N.m (80 lb in).
Verify the video display for proper operation.
Close the video display screen.
Install the bolt cover bezel.