Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the tail lamp circuit board. Refer to Tail Lamp Circuit Board Replacement .

Fig 1: Tail Lamp Assembly Removed
Courtesy of GENERAL MOTORS CORP.
Connect the tail lamp electrical connector.
Push the tail lamp assembly directly forward in order to seat the 2 locking pins.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the 2 tail lamp assembly retaining screws.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).