Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Raise the vehicle. Lifting and Jacking the Vehicle in General Information.
Remove two electrical connectors on the side of the EBCM.

Fig 1: Removing Two Electrical Connectors On Side Of EBCM

Courtesy of GENERAL MOTORS CORP.

Using a long flat bladed screw driver, release the lock tab on the electrical connector located on the back of the EBCM.
IMPORTANT: When performing the following service procedure, make sure that the TORX® screw heads are clean for the proper installation of the T 25- TORX® bit. If the TORX® screw are damaged or can not be removed, replace both the EBCM and the BPMV.

Fig 2: Releasing Electrical Connector Lock Tab

Courtesy of GENERAL MOTORS CORP.

Using a T 25-TORX® bit, remove the 4 mounting screws.
IMPORTANT: Removal may require a light amount of force. DO NOT pry on the EBCM or the BPMV.
Remove the EBCM from the BPMV.

Fig 3: Removing EBCM From BPMV

Courtesy of GENERAL MOTORS CORP.