Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Hook the cable end into the lumbar mechanism.

Fig 1: Identifying Lumbar Mechanism Cable End
Courtesy of GENERAL MOTORS CORP.
Install the cable to the lumbar spring.

Fig 2: Locating Lumbar Mechanism
Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Lumbar Cable & Clip

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the lumbar cable (2) in the cable clip (1) located on the lower seat back.
Install 2 screws (1) securing the cable to the seat adjuster.
Tighten: Tighten the lumbar cable screws to 6 N.m (53 lb in).

Fig 4: Removing/Installing Seat Adjuster Cable Retaining Screws
Courtesy of GENERAL MOTORS CORP.
Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement .
Install the seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .