Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the bulb (1) to the socket.
Wipe the bulb to ensure the bulb is free of dirt or oil.

Fig 1: Installing License Lamp Bulb To Socket
Courtesy of GENERAL MOTORS CORP.
Position the license lamp lens to the liftgate.
Verify that the license lamp lens gasket is fully seated to the liftgate.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the 2 license lamp lens retaining screws.
Tighten

Tighten the screws to 1.4 N.m (12 lb in).

Fig 2: Installing License Lamp Lens Retaining Screws
Courtesy of GENERAL MOTORS CORP.