Electronic Brake Control Module: Testing and Inspection

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:


EBCM Reprogramming-Refer to Control Module References (Programming and Relearning) .


EBCM Reprogramming

If the EBCM needs to be reprogrammed, refer to Service Programming System (SPS) (Programming and Relearning) .


Setup for Component Replacement

The brake fluid pressure sensor is not serviceable. After replacing a brake fluid presure sensor, it may be necessary to perform a brake pressure sensor calibration with the Tech 2 special function, if the DTC resets as a current code.