LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2009 >> Yukon Base, 4.8 C >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel - 4.8L, 5.3L, 6.0L Or 6.2L - Introduction >> Repair Instructions >> Fuel Pump Flow Control Module Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

    Fig 1: Fuel Pump Flow Control Module Cover & Retainers
    GM1911334Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disengage the fuel pump flow control module cover retainers (2) from the frame.
  3. Remove the fuel pump flow control module cover (1).
    4. Fig 2: Chassis Wiring Harness Electrical Connector
    GM1911337Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the chassis wiring harness electrical connector (1) from the fuel pump flow control module.
    5. Fig 3: Fuel Pump Flow Control Module & Bolts
    GM1911342Courtesy of GENERAL MOTORS CORP.
  5. Loosen the fuel pump flow control module bolts (1).
  6. Slide the fuel pump flow control module (2) towards the passenger side of the vehicle.
  7. Remove the fuel pump flow control module from the vehicle.
scientia non olet · About LEMON Manuals