LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> GMC >> 2011 >> Yukon Hybrid, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - Hybrid (LZ1) - Repair Instructions >> Repair Instructions >> Knock Sensor 1 Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Left Side Knock Sensor
    GM1402136Courtesy of GENERAL MOTORS CORP.
    CAUTION:

    Refer to Fastener Caution .

  1. Position the knock sensor (718) to the engine block and install the knock sensor bolt (739). Tighten the bolt to 25 N.m (18 lb ft).
    2. Fig 2: Knock Sensor Electrical Connector And Sleeve
    GM1965285Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (4) to knock sensor.
  3. Position the engine wiring harness sleeve (3) over the knock sensor electrical connection.
  4. Install the left front wheel and tire. Refer to Tire and Wheel Removal and Installation .
  5. If removed, install the left front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side .
scientia non olet · About LEMON Manuals