Removal and Replacement

Axle Lubricant Change

Removal Procedure





1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle Service and Repair.

Note:
If the drain plug seal is worn, replace the drain plug and seal.

2. Remove the drain plug and gasket from the rear differential housing.

Installation Procedure





Caution:
Refer to Fastener Caution Fastener Caution.

1. Install the drain plug and gasket, then tighten to 35 Nm (26 lb ft).





2. Remove the fill plug and gasket from the rear differential housing.

3. Fill the rear differential with the proper synthetic gear lubricant. Refer to Adhesives, Fluids, Lubricants, and Sealers [1][2]Fluid - Differential.

4. Inspect the gear oil level to ensure it is even with the bottom of the fill plug.

5. Install the fill plug and gasket in the rear differential housing and tighten to 35 Nm (26 lb ft).

6. Remove the support and lower the vehicle.