Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (with UGN)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Sierra 3500 HD, 2018 GMC Sierra 2500 HD, 2018 GMC Sierra 1500, 2018 Chevrolet Silverado 3500 HD, and 2018 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing Front View Camera Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Setup (if this option is available)
and follow the on-screen instructions.
If reprogramming an existing module that was previously calibrated, calibration is not required. The module retains its calibration settings during reprogramming. If a new module was programmed the module alignment must be calibrated. Using a scantool, initiate the learn procedure for Frontview Camera Module. The scantool must remain connected and on the calibration screen during the entire process.
Refer to Front View Camera Module Learn .
NOTE:
After programming is performed, it is normal to have DTC B101E 4B set until calibration is complete.