Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 GMC Sierra 3500 HD, 2018 GMC Sierra 2500 HD, 2018 GMC Sierra 1500, 2018 Chevrolet Silverado 3500 HD, and 2018 Chevrolet Silverado 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Due to continuous improvements, the on screen selections may vary from instructions below.
To program a replacement or an existing Front View Camera Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Setup (if this option is available) and follow the on-screen instructions.
- At the end of programming, choose the "Clear DTCs" function on the SPS screen.
- Following K109 Frontview Camera Module replacement and reprogramming, the module must be calibrated. Refer to Front View Camera Module Learn .