Installation Procedure
- Generator (3) - Install
- If necessary, install the generator mounting stud. (2) - Tighten 9 N.m (80 lb in)
- Generator Nut (1) - Hand tighten
- Electrical Connector (1) - Connect
- Drive Belt (1) - Install - Drive Belt Replacement
- Raise and support the vehicle. Lifting and Jacking the Vehicle
- Battery Positive Cable (3) - InstallNOTE:
Anti-rotation tab is in the 12 o'clock position (arrow).
- Battery Positive Cable Nut (2) @ Generator - Install and tighten 15 N.m (11 lb ft)
- Protective Cap (1) - Install
- Lower the vehicle.
- Remove the generator nut (1).
- Generator Shield (3) - Install - Generator Shield Replacement (LCV)
CAUTION:
Refer to Fastener Caution