Installation Procedure
- Apply a few drops of clean engine oil to the male pipe end.WARNING:
In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.
- Push both sides of the quick-connect fitting together to cause the retaining tabs to snap into place.
- Pull on both sides of the quick-connect fitting to make sure the connection is secure.
- Install the retainer to the quick-connect fitting.
- Inspect for leaks using the following procedure:
- Turn the ignition ON, with the engine OFF for 2 seconds.
- Turn the ignition OFF, for 10 seconds.
- Turn the ignition ON, with the engine OFF for 2 seconds.
- Turn the ignition OFF.
- Inspect for leaks.