Circuit/System Verification

Vehicle ON.
Verify DTC P1F59, P1F5A, P1F5B, P1F5D, or P1F5E is not set.
- If any of the DTCs are set
  Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Go to next step: If no DTC is set
Vehicle OFF. Measure and record the C1 battery voltage at the C1 battery terminals. The C1 battery voltage should stabilize between 12.4 and 12.8 V after 12 minutes of turning the vehicle OFF.
- If not in the specified range
  Refer to Battery Inspection/Test .
- Go to next step: If within the specified range
Vehicle ON, accessories OFF.
Measure and record the C1 battery voltage at the C1 battery terminals. The voltage should be at least 1 V greater than the voltage measured in step 1 but less than 15 V.
- If not in the specified range
  Refer to Circuit/System Testing
- Go to next step: If within the specified range
All OK.