Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Turn the ignition switch OFF and disconnect the battery negative (-) cable.
- Release the residual pressure in fuel line (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE
" in this group).CAUTION: When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS Repair Procedures after completion of "Release Residual Pressure in Fuel Line" work.
- Remove the intake manifold.
(Refer to INTAKE & EXHAUST SYSTEM - 5.0L Engine Mechanical System )
- Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.