LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2018 >> G90 3.3T Premium, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - 3.3L >> Camshaft Position Sensor (CMPS) >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

[Bank 1] 

WARNING:
  • DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the intake hose.

    (Refer to Engine Mechanical System - "INTAKE AND EXHAUST SYSTEM ")

  3. Disconnect the camshaft position sensor connector (A).
  4. Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.

    [Bank 1/Intake] 

    G12715642Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 1/Exhaust] 

    G12715643Courtesy of HYUNDAI MOTOR AMERICA

[Bank 2] 

WARNING:
  • DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the surge tank.

    (Refer to Engine Mechanical System - "SURGE TANK ")

  3. Disconnect the camshaft position sensor connector (A).
  4. Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.

    [Bank 2/Intake] 

    G12715644Courtesy of HYUNDAI MOTOR AMERICA

    [Bank 2/Exhaust] 

    G12715645Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals