Electronic Stability Control DTCS
ELECTRONIC STABILITY CONTROL DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C1100 | 01: Battery Voltage |
| DTC C1101 | 01: Battery-Voltage High |
| DTC C1102 | 01: Battery-Voltage Low |
| DTC C1103 | 01: Ignition Voltage |
| DTC C1114 | 01: 12V Sensor Power Fail |
| DTC C1200 | 01: Wheel Speed Sensor Front-LH Open/Short |
| DTC C1201 | 02: Wheel Speed Sensor Front-LH Range/Performance/Intermittent |
| DTC C1202 | 02: Wheel Speed Sensor Front-LH Invalid/no Signal |
| DTC C1203 | 01: Wheel Speed Sensor Front-RH Open/Short |
| DTC C1204 | 02: Wheel Speed Sensor Front-RH Range/Performance/Intermittent |
| DTC C1205 | 02: Wheel Speed Sensor Front-RH Invalid/no Signal |
| DTC C1206 | 01: Wheel Speed Sensor Rear-LH Open/Short |
| DTC C1207 | 02: Wheel Speed Sensor Rear-LH Range/Performance/Intermittent |
| DTC C1208 | 02: Wheel Speed Sensor Rear-LH Invalid/no Signal |
| DTC C1209 | 01: Wheel Speed Sensor Rear-RH Open/Short |
| DTC C1210 | 02: Wheel Speed Sensor Rear-RH Range/Performance/Intermittent |
| DTC C1211 | 02: Wheel Speed Sensor (Rear Right)-Invalid/No Signal |
| DTC C1235 | 01: Pressure Sensor (Primary) - Electrical |
| DTC C1237 | 02: Pressure Sensor - Other |
| DTC C1260 | 02: Steering Angle Sensor Circuit - Signal |
| DTC C1261 | 04: Steering Angle Sensor is Not Calibrated |
| DTC C1282 | 08: Yaw Rate & G Sensor-Electrical |
| DTC C1283 | 02: Lateral G/Longitudinal G/Yaw Rate Sensor-Signal Error |
| DTC C1285 | 04: Uncalibrated Ax Signal |
| DTC C1286 | 01: Yaw Rate & G Sensor Fail-Replace SRSCM |
| DTC C1358 | 01: AVH not Available due to EPB in Emergency Release |
| DTC C1382 | 01: Lever Hall Sensor Fault |
| DTC C1383 | 01: Actuator Hall Sensor Fault |
| DTC C1385 | 01: Vacuum Sensor-Electrical |
| DTC C1386 | 02: Vacuum Sensor-Signal |
| DTC C1501 | 01: Switch-Failure |
| DTC C1503 | 01: TCS Switch Error |
| DTC C1520 | 01: Clutch Switch |
| DTC C1527 | 01: Reverse Gear Signal Error |
| DTC C1539 | 01: In Gear Switch Error |
| DTC C1542 | 01: Brake Circuit Error |
| DTC C1604 | 04: ECU Hardware Error |
| DTC C160E | 08: P-CAN Bus Off |
| DTC C1611 | 08: CAN Timeout-EMS |
| DTC C1612 | 08: CAN Time-out TCU |
| DTC C1613 | 08: CAN Signal Error EMS |
| DTC C1616 | 08: C-CAN Bus OFF |
| DTC C1623 | 08: CAN Timeout-Steering Angle Sensor |
| DTC C1627 | 08: CAN Time-out 4WD |
| DTC C1628 | 08: CAN Timeout-Cluster |
| DTC C162A | 08: CAN Time-Out Cluster for Driving Mode |
| DTC C162B | 08: CAN Time-out ECS_IVSS11 |
| DTC C162C | 02: CAN Signal Failure ECS_IVSS11 |
| DTC C162E | 04: IVSS SW Execution Time Failure |
| DTC C1638 | 08: ACC SCC Communication Error |
| DTC C1643 | 08: CAN Time out Yaw Rate & G Sensor |
| DTC C1648 | 08: CAN Signal Error EMS for ACC SCC |
| DTC C1649 | 08: CAN Time Out ECM for ACC |
| DTC C1650 | 08: CAN Signal Error SCC |
| DTC C1656 | 08: CAN Signal Error Cluster |
| DTC C1687 | 08: CAN Time out VSM2 MDPS |
| DTC C1688 | 08: VSM2 (MDPS) Signal Error |
| DTC C16B8 | 08: AEB Communication Error |
| DTC C1702 | 04: Variant Coding Error |
| DTC C1710 | 04: Assembly line Setup is still Active |
| DTC C1713 | 04: Factory Mode Not Disabled |
| DTC C1812 | 08: CAN Timeout Gateway |
| DTC C1817 | 08: CAN Signal Error Gateway |
| DTC C2112 | 01: Valve Relay Error |
| DTC C2126 | 01: Vacuum Pump Relay Drive Pin Open Short |
| DTC C2220 | 01: Rear LH Actuator |
| DTC C2222 | 08: Actuator Failure 4WD |
| DTC C2224 | 01: Rear RH (or rear) Actuator |
| DTC C2227 | 07: Excessive Temperature Of Brake Disc |
| DTC C2228 | 08: Actuator Failure TCU |
| DTC C2229 | 08: Actuator Failure EMS |
| DTC C2231 | 02: Vacuum Pump System Fail |
| DTC C2243 | 08: Gear Fault |
| DTC C2380 | 01: ABS TCS ESP valve error |
| DTC C2402 | 01: Motor Electrical |
| DTC C2416 | 01: Motor Short or Open LH |
| DTC C2417 | 01: Motor Short or Open RH |