LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Genesis >> 2021 >> GV80 2.5T Advanced, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 28 (4WD Control Diagnosis) >> DTC P3102-00: Control Module - Control ASIC Overtemperature >> DTC Information And Inspection >> Visual Check
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Visual Check

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch ON.
  2. Connect to the GDS and clear the DTC.
  3. Turn the ignition switch OFF.
  4. Connect and set the vehicle to "Vehicle Lift" and lift it safely (Refer to LIFT AND SUPPORT POINTS ).
  5. Check the installation of 4WD ECU if it is clogged (contaminated) by dirt or leaves:

    Such as foreign substance around connector.

    If it is, clear them.

  6. Keep the engine ON.
  7. If DTC returns, replace 4WD ECU (* Refer to the procedure of replacing 4WD ECU - REPAIR PROCEDURES )

    * (Replacing 4WD ECU) S/W Management: Back-up/input learning value and conduct "TC Clutch Calibration".

scientia non olet · About LEMON Manuals