(Front Camera Removal And Installation)

Abbreviated Procedures

Work		H/W	Tightening torque N.m (kgf.m/lb-ft)	SST/Equipment	Chemical	etc
Removal
1	Disconnect the battery negative (-) terminal	-	-	Diagnostic tool	-	-
2	Remove the side garnish.	Fastener	-	-	-	-
3	Remove the fender garnish	Fastener	-	-	-	-
4	Remove the front trunk mat	-	-	-	-	-
5	Open the front trunk plug hole	-	-	-	-	-
6	Remove the front trunk	Bolt	7.8 - 11.8 (0.8 - 1.2/5.8 - 8.7)	-	-	-
7	Disconnect the front trunk connector	-	-	-	-	-
8	Open the charge door	-	-	-	-	-
9	Remove the charge door inlet cap	-	-	-	-	-
10	Remove the PE room side cover [LH/RH]	Clip	-	-	-	-
11	Remove the front bumper upper cover	Clip	-	-	-	-
12	Remove the front bumper assembly	Clip/Screw	-	-	-	-
13	Disconnect the front bumper main connector	-	-	-	-	-
14	Disconnect the front radar connector	-	-	-	-	-
15	Remove the front radar	Bolt	8.8 - 10.8 (0.9 - 1.1/6.5 - 8.0)	-	-	Refer to SHOP REPAIR INFORMATION
Installation
Install in the reverse order of removal
Additional work
Using a diagnostic tool Variant Coding, Inspection/Adjustment Special Service Tools (Calibration work) SCC Setting Tripod (09964-C1300) SCC Setting Beam (09964-C1200) SCC Setting Reflector (09964-C1100) Calibration Reflector (0K964-J5100)