Connector [A]
WARNING: This page is about a different variant/trim than selected.
| Pin No | Description |
|---|---|
| 1 | - |
| 2 | - |
| 3 | - |
| 4 | - |
| 5 | - |
| 6 | - |
| 7 | ETC Motor control (+) |
| 8 | ETC Motor control (-) |
| 9 | Cooling Pan PWM control |
| 10 | Vehicle Speed signal output |
| 11 | Engine Control Relay control |
| 12 | Fuel Pump Relay control |
| 13 | Electronic coolant pump (EWP) signal input |
| 14 | - |
| 15 | - |
| 16 | Intake Air Temperature Sensor (IATS) signal input |
| 17 | MAP Sensor (MAPS) signal input |
| 18 | - |
| 19 | A/C #1 Relay control |
| 20 | - |
| 21 | Start Relay (Low) control |
| 22 | EWGA DC Motor control (+) |
| 23 | EWGA DC Motor control (-) |
| 24 | - |
| 25 | - |
| 26 | RCV Control Solenoid Valve control |
| 27 | - |
| 28 | - |
| 29 | - |
| 30 | - |
| 31 | Crankshaft Position Sensor (CKPS) signal input |
| 32 | - |
| 33 | Sensor Shield [KS] |
| 34 | Sensor ground [Coolant Temperature Sensor (Electronic Water Pump (EWP) Side)] |
| 35 | Oil Pressure signal input |
| 36 | - |
| 37 | Boost Pressure Sensor (BPS) signal input |
| 38 | Sensor ground [MAPS] |
| 39 | - |
| 40 | Sensor ground [BPS] |
| 41 | - |
| 42 | - |
| 43 | - |
| 44 | - |
| 45 | - |
| 46 | Variable Force Solenoid (VFS) control |
| 47 | Canister Close Valve (CCV) control |
| 48 | - |
| 49 | Sensor ground [RPS] |
| 50 | - |
| 51 | - |
| 52 | Sensor Ground [CMPS (Bank 1/Intake)] |
| 53 | Sensor ground [CKPS] |
| 54 | Sensor ground [TPS] |
| 55 | Sensor ground |
| 56 | Sensor ground [OPTS] |
| 57 | - |
| 58 | Sensor ground [EWGA] |
| 59 | - |
| 60 | - |
| 61 | - |
| 62 | - |
| 63 | - |
| 64 | E-CVVT relay power |
| 65 | E-CVVT motor [+] control |
| 66 | Oxygen Sensor (HO2S) [Bank 1/Sensor 2] Heater Control |
| 67 | Oxygen Sensor (HO2S) [Bank 1/Sensor 1] Heater Control |
| 68 | LDC signal input |
| 69 | - |
| 70 | Rail Pressure Sensor (RPS) Signal Input |
| 71 | Start Relay (High) control |
| 72 | - |
| 73 | - |
| 74 | Throttle Position Sensor (TPS) #2 signal input |
| 75 | Throttle Position Sensor (TPS) #1 signal input |
| 76 | - |
| 77 | Oil Temperature signal input |
| 78 | Sensor Power (+5V) [CMPS, CKPS, MAPS, BPS] |
| 79 | Sensor Power (+5V) [TPS] |
| 80 | - |
| 81 | Sensor ground [KS] |
| 82 | Rc (Compensative Resistance) |
| 83 | Rc/Rp (Pumping cell Voltage) |
| 84 | Sensor Ground [HO2S (Bank 1/Sensor 1)] |
| 85 | E-CVVT relay power |
| 86 | E-CVVT motor [+] control |
| 87 | E-CVVT motor [-] control |
| 88 | E-CVVT motor [-] control |
| 89 | - |
| 90 | - |
| 91 | Electric Waste Gate Actuator (EWGA) Position Sensor Feedback Signal Input |
| 92 | - |
| 93 | - |
| 94 | Camshaft Position Sensor (CMPS) [Bank 1/Intake] Signal Input |
| 95 | - |
| 96 | Start Motor Control Switch |
| 97 | Coolant Temperature Sensor [Coolant Temperature Control Assembly side] signal input |
| 98 | - |
| 99 | Sensor Power (+5V) [RPS] |
| 100 | Sensor Power (+5V) [CMPS, EWGA] |
| 101 | Sensor Power (+5V) [OPTS] |
| 102 | Knock Sensor (KS) signal input |
| 103 | VS+ (NERNST Cell Voltage) |
| 104 | VS-/IP- (Virtual Ground) |
| 105 | Oxygen Sensor [Bank 1/Sensor 2] signal input |