Park/Neutral Switch (Tracker)
- Disconnect negative battery cable. Disconnect switch connector located under intake manifold. This is a round type connector containing 4 wires.
- Using ohmmeter check for continuity between specified wires with gearshift in proper location. See PARK/NEUTRAL SWITCH CONTINUITY table. Continuity should exist in these gears only.
PARK/NEUTRAL SWITCH CONTINUITY
| Gear Position | Wire Colors | |
|---|---|---|
| Metro | ||
| Park | Black & Blue/White, Black/Red & Black/Yellow | |
| Reverse | Red & Yellow | |
| Neutral | Black & Blue, Black/Red & Black/Yellow | |
| Drive | Black & Green | |
| 2nd Gear | Black & Green/Red | |
| Low | Black & Green/Blue | |
| Storm (3-Speed) | ||
| Park | Black/Yellow & White/Blue | |
| Reverse | Red/Black & Red/Blue | |
| Neutral | Black/Yellow & White/Blue | |
| Tracker | ||
| Park or Neutral | Black/Yellow & Black/Red | |
| Reverse | Red & Yellow | |
NOTE:
For vehicle speed sensor, following procedure applies if Code 24 is stored in ECM or suspected incorrect input from vehicle speed sensor exists. Connector C1 (10-wire connector) is located on right corner of instrument cluster and C2 (12-wire connector) is located on left side of instrument cluster.