October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
RWAL System Electrical Circuit Check
- Remove RWAL EBCM from under dash so rear of harness connector can be accessed with a DVOM. See RWAL ELECTRONIC BRAKE CONTROL MODULE
under REMOVAL & INSTALLATION.
- Check voltage at each terminal of connector under conditions as described in the RWAL EBCM PIN VOLTAGES
table. Also, see Figure
.
RWAL EBCM PIN VOLTAGES
| Pin No. |
Circuit |
Voltage |
Condition |
| 1 |
Isolation Solenoid |
0 |
During Normal Driving |
| " |
" |
10-15 |
During Hard Braking |
| 2 |
BRAKE Warning Light |
10-15 |
When BRAKE Light Is Off |
| " |
" |
0-3 |
When BRAKE Light Is On |
| 3 |
4WD Signal |
10-15 |
In 2WD |
| " |
" |
0-0.5 |
In 4WD |
| 4 |
Valve Reset Switch |
4-5 |
During Normal Driving |
| " |
" |
0-0.5 |
During Hard Braking |
| 5 |
Not Used |
N/A |
N/A |
| 6 |
Not Used |
N/A |
N/A |
| 7 |
Diagnostic Test |
3-5 |
When Terminal Is Open |
| " |
" |
0-0.5 |
When Terminal Is Grounded |
| 8 |
Stoplight Switch |
0-0.5 |
With Pedal Released |
| " |
" |
10-15 |
With Pedal Depressed |
| 9 |
Dump Valve Solenoid |
0 |
Normal Driving |
| 10 |
Power Supply (Battery) |
10-15 |
Normal Condition |
| 12 |
Power Supply (Ignition) |
10-15 |
With Ignition On |
| 15 |
EBCM Ground |
0 |
Normal Condition |
| 16 & 17 |
Wheel Speed Sensor |
3.5 |
At About 20 MPH |