October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Speed Sensor
- Raise and support front of vehicle. Set parking brake and block rear wheels. Back probe voltmeter or test light positive probe into Yellow/Black wire terminal at control unit connector.
- Connect negative probe to ground. Start engine. Place vehicle in second position (gear selector in 2 position for auto. trans.) and accelerate slowly. Battery voltage should be as indicated in SPEED SENSOR VOLTAGE CHECK table.
SPEED SENSOR VOLTAGE CHECK
| Speed |
Voltage |
| Below 11 MPH |
Yes |
| Above 16 MPH |
No |
- If voltmeter readings do not correspond to above MPH ranges, install new speed sensor and retest. If voltage was not present during step 2), check for bad electrical connection, fuse or faulty speed sensor. Replace or repair as necessary and retest.