Code 17 - Vehicle Speed Sensor (VSS)
- Block rear wheels and set parking brake. Raise front of vehicle and support with safety stands. With ignition off, connect ECU test harness between ECU and ECU connector. See Figure . Turn ignition on.
- Slowly rotate left front wheel while measuring voltage between terminals B16 (pos.) and A18 (neg.). If voltmeter pulses between zero and 5 volts, substitute a known good ECU. If condition is rectified, replace original ECU.
- If voltmeter does not pulse between zero and 5 volts, repair open or short in Yellow/Red wire between ECU terminal B16 and speed sensor or replace faulty speed sensor.