Driver's Switch Input Test

NOTE: The control unit is built into the driver's switch, and only controls driver's door window operation.

NOTE: Recheck the connections between the 14-P and 1-P connectors, and the driver's switch, then replace the driver's switch if all input tests prove okay.

Remove the driver's door trim panel. See DOOR TRIM PANEL under REMOVAL & INSTALLATION.
Disconnect the 14-P and 1-P connectors from the driver's switch.
Make the following input tests at the harness pins. See Fig 1 and Fig 2 .

Fig 1: Driver's Switch Input Test (1 Of 2)

Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Driver's Switch Input Test (2 Of 2)

Courtesy of AMERICAN HONDA MOTOR CO., INC.