Abs Function Test: Testing
- With ignition off, connect ABS Tester (07HAJ-SG0010A or 07HAJ-SG0010B) to Orange
6-pin test connector, located under passenger's seat. Start engine. Release parking brake. Place mode selector to "1" position. Push START TEST button. See Fig 1
. TEST IN PROGRESS light should come on. Within 1-2 seconds, all 4 monitor lights should come on. If tester lights do not illuminate, ABS tester is faulty.
Courtesy of AMERICAN HONDA MOTOR CO., INC.
- If ABS warning light comes on, 6-pin connector or ABS tester harness is faulty. Turn mode selector to "2" position. Press brake pedal. Push START TEST button. ABS warning light should not come on and kickback should be felt on brake pedal.
- If ABS warning light comes on or kickback is not felt, see ANTI-LOCK (ABS) WARNING LIGHT
under TROUBLE SHOOTING. Place mode selector in "3", "4" and then "5" positions. Repeat step 2) for each test mode. Results should be same as in test mode "2". If results are not same as in test mode "2", see ANTI-LOCK (ABS) WARNING LIGHT
under TROUBLE SHOOTING.
- Breakdown of each test mode is as follows: