Air Mix Control

Heater Control Panel Overhaul:

Air Mix Control Cable Replacement:

Air Mix Control Cable Replacement
1. Cut the inner cable on the lever side of the cable holder, then remove both pieces of the inner cable.
2. Using a sharp knife, cut completely through the end of the cable housing at the two locations.
3. Slide the large section of the cable housing out of the cable holder, being careful not to damage the cable stops.
4. Carefully remove the cut pieces of the cable housing with a small flat tip screwdriver.
5. Hook the tip of the new air mix cable to the temperature control lever, then push the cable housing into the cable holder until it locks place.

NOTE: After assembly, check that the temperature control lever slides smoothly through the full stroke from right to left.