Transmission Position Sensor/Switch: Service and Repair

A/T Gear Position Switch Replacement:

1. Remove the center console, then disconnect the 14P connector from the switch.
2. Remove the two switch mounting nuts, and replace the switch.
3. Position the slider on the new switch to "Neutral" as shown above.
4. Shift the shift lever to "Neutral", then slip the switch into position.
5. Attach the switch with the two nuts.
6. Test the switch in the "P" and "N" positions. The engine should start when the shift lever is in position "P" and "N" anywhere in the range of free play.
7. Connect the 14P connector, clamp the harness, and install the center console.