Both Mirrors Inoperative
- Check No. 17 fuse (7.5-amp). Replace as required. Remove power mirror switch. DO NOT disconnect switch from harness. See POWER MIRROR SWITCH under REMOVAL & INSTALLATION.
- Turn ignition on. Using a voltmeter, check for voltage between terminal No. 2 (Black/Yellow wire) and ground. See Fig 1
. If battery voltage exists, go to next step. If battery voltage does not exist, repair open circuit in Black/Yellow wire between mirror switch and fuse box.
- Using an ohmmeter, check for continuity between terminal No. 4 (Black wire) and ground. If continuity does not exist, repair open circuit in Black wire or poor ground connection. If wiring is okay, substitute known good switch and retest.
Courtesy of AMERICAN HONDA MOTOR CO., INC.