LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2000 >> Insight >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Wheel Alignment Specifications & Adjustment Procedures) >> Wheel Alignment Procedures >> Toe-In Adjustment >> Prelude With ATTS
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Prelude With ATTS

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2000 Honda Prelude, 2000 Honda Odyssey, 2000 Honda Civic, 2000 Honda CR-V, and 2000 Honda Accord. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Preludes equipped with Active Torque Transfer System (ATTS) require reprogramming of ATTS control unit for steering angle sensor neutral position, after toe-in adjustment is performed on front wheels. See appropriate article in TRANSMISSION section.
  1. Check caster and camber. See WHEEL ALIGNMENT SPECIFICATIONS  . Adjust if necessary. Set steering angle sensor in neutral position (steering wheel in straight-ahead position). Secure steering wheel in straight-ahead position. Connect SCS Service Connector (07PAZ-0010100) or fused jumper wire between 2-pin service check connector.
  2. Connector is located behind right front of center console. Active Torque Transfer System (ATTS) indicator should illuminate. Maintain this condition during inspection and adjustment of toe-in.
  3. Ensure parking brake is released. Measure rear wheel toe-in. See WHEEL ALIGNMENT SPECIFICATIONS  . If rear toe-in needs adjustment, hold adjusting bolt on rear lower control arm and loosen lock nut. Adjust rear toe-in by turning off-set adjusting eccentric bolt until toe-in is correct. Install lock nut, and tighten it while holding adjusting bolt. See Figure . See TORQUE SPECIFICATIONS  .
  4. Measure front wheel toe-in. See WHEEL ALIGNMENT SPECIFICATIONS  . If adjustment is needed, loosen tie rod lock nuts. Turn both tie rods equally in same direction until front wheels are in straight-ahead position and toe-in reading is correct. Tighten tie rod lock nuts. See TORQUE SPECIFICATIONS  . Reposition tie rod boots if they are twisted. Remove SCS Service Connector (07PAZ-0010100) or fused jumper wire.
scientia non olet · About LEMON Manuals