Audio Unit Removal/Installation

SRS components are located in this area. Review the SRS component locations, (see AIR BAG RESTRAINT SYSTEMS , and the precautions and procedures (see AIR BAG RESTRAINT SYSTEMS ) in the SRS before performing repairs or service.

NOTE:

Put on gloves to protect your hands.
Take care not to scratch the dashboard and related parts.

Make sure you have the anti-theft codes for the radio and the navigation system, then write down the frequencies for the radio's preset buttons.
Remove the center panel (see CENTER PANEL REMOVAL/INSTALLATION )
Disconnect the audio unit connector (A) and the antenna lead (B) from the audio unit.
Remove the screws (A) and the audio unit (B).

Fig 1: Removing Screws & Audio Unit (With Navigation System)
Courtesy of AMERICAN HONDA MOTOR CO., INC.

Fig 2: Removing Screws & Audio Unit (Without Navigation System)
Courtesy of AMERICAN HONDA MOTOR CO., INC.
Install in the reverse order of removal, and note these items:
- Make sure the audio unit connectors are plugged in properly, and the antenna lead is connected properly.
- Enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets.