LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2000 >> Odyssey Cargo >> Repair and Diagnosis >> Steering >> Steering Column >> Power Steering System >> Pump Overhaul >> Disassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Pump Overhaul: Disassembly

NOTE: Refer to the Exploded View as needed during the following procedure.
  1. Drain the fluid from the pump (see Fluid Replacement  ).
  2. Remove the power steering pump (see Pump Replacement  ).
  3. Hold the power steering pump (A) in a vise with soft jaws, hold the pulley (B) with the special tool, and remove the pulley nut (C) and pulley. Be careful not to damage the pump housing with the jaws of the vise.
    Fig 1: Holding Power Steering Pump In A Vise With Soft Jaws
    G01505734Courtesy of AMERICAN HONDA MOTOR CO., INC.
  4. Loosen the flow control valve cap with a hex wrench, and remove it and the O-ring, flow control valve and spring.
  5. Remove the pump cover and pump cover seal.
  6. Remove the outer side plate, pump cam ring, pump rotor, pump vanes, side plate and O-rings.
  7. Remove the snap ring, then remove the subvalve from the pump housing.
  8. Remove the circlip, then remove the pump drive shaft by tapping the shaft end with the plastic hammer.
  9. Remove the pump seal spacer and pump seal.
scientia non olet · About LEMON Manuals