LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Honda >> 2000 >> Prelude Base, Standard >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft & Keyless Entry System >> System Tests >> Driver's Multiplex Control Unit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Driver's Multiplex Control Unit

  1. Remove underdash fuse/relay box. See UNDERDASH FUSE/RELAY BOX  under REMOVAL & INSTALLATION. Remove driver's multiplex control unit from underdash fuse/relay box. Disconnect driver's multiplex control unit harness connector. Check driver's multiplex control unit harness connectors for loose, damaged or corroded terminals. If problem exists, repair as necessary and retest system. If connectors are okay, go to next step.
  2. With driver's multiplex control unit connectors disconnected, perform driver's multiplex control unit input tests at indicated connector terminals. See Fig 1 . Go to next step.
  3. Connect driver's multiplex control unit connectors. Perform input tests by backprobing indicated connector terminals. See Fig 2 . If any input test is not within specification, locate and repair problem, then recheck system. If input tests are within specification, test next suspected control unit.
Fig 1: Driver's Multiplex Control Unit Input Test (1 Of 2)
G00012891Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 2: Driver's Multiplex Control Unit Input Test (2 Of 2)
G00012895Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About LEMON Manuals